expresso Posted February 17, 2007 Posted February 17, 2007 hi - i decided to add a spot fan to my system and connect the two rear fans to run off the PSU instead of the board - and after its all connected - the system dosnt boot anymore ? dosnt power up - it starts and shuts down right away - one time i got into windows and i changed the setting for the spot fan which was connected to the chip fan header on the MB - and then after that - it didnt power up anymore - it was having problems before i made that change in the chip speed fan - but now nothing - the MB has the yellow leds - i am starting to think its the PSU - i had it a year - i am leaving it to clear the cmos overnight and try again tomorrow - i have only one drive connected - and 2 fans for the Rad and pump for the WC - and it still didnt boot - any ideas what happened - it was working fine before - but a few times it bsod'ed on me - also i got a checksum error the only time i though it was about to boot - i hit delete and set the defualts - then it couldnt power up again - does anyone think that my psu is not enough power for what i am running in my Sig ? or maybe just a bad unit ? the fans i am running are TT smart case fans - 3 120mm and two 92mm - and i was adding a spot fan to the board chip fan header -- anything i did wrong or is it just too much power for the PSU or a bad PSU ? thanks - i have it clearing the Cmos now - Quote Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.