Reset settings when adding RAM?

[Baja Bum]

Hey,

 

I'm new to this board and Overclocking. Just built my system last month.

 

Followed some tips here and from the old board (dficlub.org...) and over the last 2 weeks I gradually O.C. my E6400 from 2.13 to 2.623Mhz. RAM at 4.4.4.12 with 533Mhz (1:1), 15.6us Refresh mode, Write precharge 13, Read delay(same) 11, delay (diff) 2, 2, 2, 1, 7 Data A 2.25, Data B 2.25, 2.25,2.25,2.25.

 

Everything running smooth @ 39C-41C on air-cooled 3 fan system.

 

My RAM are Kingston 1GB 240-Pin SDRAM DDR2 667 (PC2 5300) KVR667D2N5/1G and 512MB 240-Pin SDRAM DDR2 667 (PC2 5300)KVR667D2N5/512 = 1.5GB with the above O.C. settings.

 

I'm planning on adding another 1GB (same as above) from Newgg this week. Do I simply install the new RAM or do I have to reset my Genie Bios setting to default before installing? Also, should I leave the 512MB card in to = 2.5GB? Or should I leave the 512MB card uot?

 

Same question I guess for any additions I make... like Video cards etc. Do I leave the O.C. settings or reset to default when installing???

 

May seem trivial to you guys, but I like researching and getting the right methods before I screw things up... which is usual.

 

Thanks,

 

Baja Bum

 

DFI 975x - BIOS 10/26/2006 (97TIDC15)... Couldn't get the 97TIDCO1 to load.

E6400 @2.623Mhz

1.5GB Kingston 1GB 240-Pin SDRAM DDR2 667 (PC2 5300) + 512MB same specs. at 533Mhz: 4.4.4.12

connect3D Radeon 1900GT

WD 250GB16 - XP Pro sp2

WD 150GB16 - Vista Beta

Antec Trio 650W Power Supply