efferman Posted December 3, 2006 Posted December 3, 2006 Hello Please excuse my bad english, i will give my best. My LanpartyUT NF4 Ultra-D has unrequested rebooted every Day in shorter Distances. I have Tried a single Core CPU, an other Graphicscard, Power Supply Unit, HDD and Ram. Without an effect at the Reboots. My Last Hope was an Bios Update with the newest Bios on the DFI Homepage and the Winflash Utility. After the reboot only the HDDs are running, no Picture was seen on the monitor. After that all, i am not sure what is to do. The RMA section on http://www.dfi.com.tw/RMA/rma_request_step0_de.jsp doesnt work or i am to silly. The Mainboard was bought at 12.September 2006 in an little Computerstore. Share this post Link to post Share on other sites More sharing options...
Sharp Posted December 3, 2006 Posted December 3, 2006 Hello, Have you tried clearing the CMOS for 10mins with the pc off? Clear your CMOS for 10 minutes # Remove the power cord from the back of the power supply. # Move the CMOS jumper to the clear position and leave it there for 10mins. # Make sure you move it back to the save position after. Share this post Link to post Share on other sites More sharing options...
efferman Posted December 3, 2006 Posted December 3, 2006 Thank You for your fast Reply. I proceed "Clear CMOS" in this minute. I didnt know that the old bios is after an update is doesnt deleted. If the Board Start now, is the Reboot problem solved too ? Share this post Link to post Share on other sites More sharing options...
Sharp Posted December 3, 2006 Posted December 3, 2006 No the reboot problem could be many things. Share this post Link to post Share on other sites More sharing options...
efferman Posted December 3, 2006 Posted December 3, 2006 Have you an idea where my problem is hint. With the same Hardware, but an another Mainboard, i dont have any problem. The system was Cooled by water and the Case are very good Ventilated. Share this post Link to post Share on other sites More sharing options...
Sharp Posted December 3, 2006 Posted December 3, 2006 As a small hint , memory timings need adjusting. Share this post Link to post Share on other sites More sharing options...
efferman Posted December 3, 2006 Posted December 3, 2006 Bios @ default and RAM @ SPD is not stable ? First i overcklocked the CPU to 11/240 and it was over an month Primestable. When the problems begin i set the bios @ default, but the problems are not solved Share this post Link to post Share on other sites More sharing options...
Torch Posted December 3, 2006 Posted December 3, 2006 Try booting with only one Ramstick. After succesfull booting add the other Stick,oh btw use only orange Slots. Share this post Link to post Share on other sites More sharing options...
efferman Posted December 3, 2006 Posted December 3, 2006 Thanks for this tip, but i tried this with all my Ram Sticks in all Slots, without any success. Share this post Link to post Share on other sites More sharing options...
red930 Posted December 4, 2006 Posted December 4, 2006 Try another PSU. That Tagan 480 is at the very bottom limit of what works good with these boards. Share this post Link to post Share on other sites More sharing options...
efferman Posted December 4, 2006 Posted December 4, 2006 Need the Powersupply more Amps @ the 12V Rail ? Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now