Bios for Corsair CMX512-3200C2PRO

[turna]

Hello

 

i have CMX512-3200C2PRO (CMX512-3200C2PRO XMS3202 V4.3 0521226-1 = Samsung TCCX

)

 

i got some bluscreen errors while starting windows..

 

i run memtest while booting and it gives 0 errors. i think my ram is okay but is not compatible with ultra-d..

 

can i solve this problem with bios ?

 

btw ,now i am using kingston ddr400 value rams.. until solve this issue

[red930]

So you have ran both memory in dual channel (Which slotted dimms [yellow or orange]) and memtest would work just fine? Which test did you perform and for how long? I would do TEST#5 since that is a very extreme memory torture, run it about 35-40 times. Also there is a diagnostic LED at the bottom left of your board. Have you noticed any red LED'S stay on after POST (after the beep)? Finally if you haven't connected all of your power plugs to the motherboard please do so (four to be exact [24pin, 4pin(12v), 4pin(molex), and 4pin(floppy)].

Another thing, before you attempt any suggestions here, please go into the bios and set the "optimized default settings" and save and exit, then go back and change the four primary timings for your memory and check how much vdimm (memory voltage) your memory needs at stock. Please do run your system at stock. GOOD LUCK!

[turna]

hello ,i check the timings then i see my fault i correct it and my rams are working well..

 

but i have only 3 power connections to my board. 24 pin ,12 V and 4 pin like harddisk plug... should i connect any more ?

[turna]

????

[Baditude]

You need all 4 power connectors plugged into the motherboard . The 24 pin, 4pin square, 4 pin rectangler, and a small 4 pin floppy power connector.