Jump to content
Sign in to follow this  
mrtell

cpu fan temps

Recommended Posts

Just done a partial build with a freezer 64 pro heatsink/fan.

fan does not spin because the temp according to the bios is 22 and i cannot lower the setting for cpu fan shutdown less than 25 so fan will not spin.

This would be fine if the board read the temps correctly but as I am always being told the board reads the temps way out.

Any suggestions please.

Also how far are the temp readings out and is one venus just the same as any other Venus where temp readings are concerned?

thanks

Share this post


Link to post
Share on other sites

I'd guess you are fine. They are generally 10C too low. Try putting your CPU under a load (Prime would be fine) and get the temps above 25C. If the fan still does not kick in, you may have a problem.

 

(I assume you already verified that the fan is installed correctly and is receiving power? Of course you did!)

Share this post


Link to post
Share on other sites

dont use the fan header on the mobo then the fan will run 100% all the time.

or just try using ITE smart guardian or speed fan . i belive these programs will let you alter fan speed

Share this post


Link to post
Share on other sites

Once the sides are on the case and I overclock the cpu that should raise the cpu temps.

Or like has been said just connect direct to power supply.

Just worried me a bit at first when the fan did not spin and I did not know how much the boards temp was being miscalculated.

Share this post


Link to post
Share on other sites

inn the bios, in the fan speed setting

 

Fan fully on = 25°C

Fan off = 26°C

 

some here use that setting and the fan will always spin at full speed

 

hope this help

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×