GonzoDamon Posted February 7, 2006 Posted February 7, 2006 This is my first build. I must be a glutton for punishment, because I chose the DFI UT nF4 Sli-DR Expert. The onyl drive that I have for this build is a Seagate Barracuda 7200.9 250GB 7200 RPM SATA. Is this going to be hard to build with? I was under the impression that the board would be SATA ready... My case will be arriving Wednesday. HORRAY! So I am still doing pre-build research. I have the step-by-step procedure that jacobsen wrote, which is for the nF4 SLi-D, but should still be helpful. Does anyone else have a checklist of things to make sure I am doing right or things that I should consider? Any help or suggestion will be appreciated! Share this post Link to post Share on other sites More sharing options...
lowboy Posted February 7, 2006 Posted February 7, 2006 Should work fine. Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now