Dual Channel Booting Problems

[Ozan Baseski]

I am using the computer in my signature for a few months. Everything was ok at the beginning but 10-15 days ago problems start to show up while booting. Here's my new problem. When I first boot my computer it usually doesn't boot and stays with 3 red leds on. I then shut off and remove one sticj near the cpu socket and then the machine boots fine. I again shut down after a successful booting and replace the ram in its place and it usually boots up fine. But this problem continues everyday. I tried with tccd and value ram also and there's no difference. I tried with air cooling too but the result is the same. And sometimes when it hangs up with 3 lights on and nothing on the screen, I push the power button to shut it down but after 2 seconds I realize that the leds turn off and the system powers up. But this last one occurs very rarely.

So anybody can help me with my problem? I sometimes also hear about booting with dual channel ram with this expert board.

[Ozan Baseski]

I forgot to say that I flashed my bios to the last official 07/12 bios of the Expert. But still no change

[boatasiaus]

Have you run memtest on the individual sticks of ram?

[Ozan Baseski]

I checked all the rams I used one by one on the far orange slot with memtest and they are fine. I checked them with prime also. System usually hangs with dual ram, I sometimes have to loosen the timings to 2T in order to boot it. And of course the overclock capacity of my system is really diminished too.

[boatasiaus]

Are you overclocked or is this at stock?

[Ozan Baseski]

I returned to stock speeds since this problem happenned. I can't overclock anymore even if I want to now. The machine won't boot up regularly on stock speeds.