VIPER_SK Posted January 3, 2006 Posted January 3, 2006 Hi, I have a question abaut the dual channel memory, I have Crucial Ballistix 1GB 184-Pin DDR SDRAM, and the configuration from the sign. I'm thinking to get another gb of ram http://www.newegg.com/Product/Product.asp?...N82E16820146549, will my system work in dual channel mode after installing the new memory? I have to change someting in the bios to maked work in dual channel? Share this post Link to post Share on other sites More sharing options...
Kawasaki 1 Posted January 3, 2006 Posted January 3, 2006 These SHOULD be in dual channel right away (nothing in bios to change to enable dual channel, that depends on the colored slots you have them in) as long as you put them in the same colored slots. Also, when running 4x512, you need to disable CPC in Genie Bios and remember, if you are OCing, 4x512 is hard to OC with, so if they won't oC, then just set them at their SPD timings and run at stock speed. Share this post Link to post Share on other sites More sharing options...
VIPER_SK Posted July 1, 2006 Posted July 1, 2006 Hello again. I have a problem running my 2gb Crucial Ballistix in dual channel mode. Everithing is in default. In the beginnih when I get the second 1gb of memory everithing was running excellent. But in the last couple of months, I'm running the memory in non dual channel mode. When I put the memory in dual channel mode, sometimes the system loads windowsxp, but right after the desktop appears, the system restarts. Any suggestions? P.S. I purchase a good memory and board to do some overclocking, but I don't have time :sad:. Share this post Link to post Share on other sites More sharing options...
lowboy Posted July 1, 2006 Posted July 1, 2006 There is a ton of information on your ram and settings posted here on forum just use search feature and you should find everything you need. The OC guide very good source for information on setting up memory. Share this post Link to post Share on other sites More sharing options...
Recommended Posts