Jump to content


Photo
- - - - -

Problems after following "Complete guide to OCing"


  • Please log in to reply
17 replies to this topic

#13 Zaneha

Zaneha

    New Member

  • Members
  • 4 posts

Posted 01 January 2006 - 12:06 PM

Oh sorry....Yes i am using memtest and it says 201 mhz (DDR 400) anything above that stalls boot at post.

#14 madu

madu

    Geek

  • Members
  • PipPipPip
  • 949 posts

Posted 01 January 2006 - 06:42 PM

I may be wrong, but 2-3-3-6 seems a bit tight, isnt it? no? correct me if i'm wrong.
Also, 230 seems pretty good for memory, if you are using DDR400.. I couldnt go past 225 with mine.

#15 J054

J054

    Member

  • Members
  • PipPip
  • 72 posts

Posted 01 January 2006 - 08:09 PM

dont put LDT at 4, set it to auto.

#16 J054

J054

    Member

  • Members
  • PipPip
  • 72 posts

Posted 01 January 2006 - 08:12 PM

could you post your bios settings, ie fsb, voltage, multi, dram settings etc...

Then we can see what your doing and would be easier, plus im curious as to what you got your 3200+ to.

#17 DublinGunner

DublinGunner

    Member

  • Members
  • PipPip
  • 92 posts

Posted 02 January 2006 - 05:56 AM

Always change important settings manually (like LDT multi) set it to 4x, do not leave it at auto.

#18 madu

madu

    Geek

  • Members
  • PipPipPip
  • 949 posts

Posted 02 January 2006 - 06:15 AM

Always make sure your HTT is around the specified frequency range.
Correct me if i'm wring, but I think Mr.Wu has done a pretty good job by putting that "auto" setting in the LDT. I don't see it would make anything bad by keeping it at "auto". I maybe wrong. Dont quote me. But what you need to take out of "auto" and put manually is a CPU/FSB multiplier. Put it to whatever your default is.