TehBrent Posted December 30, 2005 Posted December 30, 2005 I have everything hooked up, and in my case. I attempt to turn it on using the switch on the board. (Two orange LED turn on (by ram, and butom right corner.( It starts up... then a second pasts and a long (1.5 scond) beep goes. The CPU fan shuts off after. I see four LED red lights on the buttom left. Then 3 of them go out, and the farthest left one stays on. Little help? :cat: Share this post Link to post Share on other sites More sharing options...
TehBrent Posted December 30, 2005 Posted December 30, 2005 Erm, I might not have set my HDD jumpers right. Could that be the problem? Share this post Link to post Share on other sites More sharing options...
st0nyk Posted December 30, 2005 Posted December 30, 2005 Sounds like you need to plug in a video card if the last LED fails to go out... Share this post Link to post Share on other sites More sharing options...
TehBrent Posted December 30, 2005 Posted December 30, 2005 Videocard was in... Maybe I should try to put videocard in better. Was kinda hard. Didn't wanna sit down. Share this post Link to post Share on other sites More sharing options...
TehBrent Posted December 30, 2005 Posted December 30, 2005 I tried pushing in all way.. still red light is on (this time I got it in good) Share this post Link to post Share on other sites More sharing options...
TehBrent Posted December 31, 2005 Posted December 31, 2005 Maybe I have to chnage it to single VGA mode? Share this post Link to post Share on other sites More sharing options...
killermiller Posted December 31, 2005 Posted December 31, 2005 Why would it be in dual mode, are you using 2 vga cards? either way I would get it to work with 1 card first before you jump right in to sli. Your sig doesn't say that you are using 2 cards. Share this post Link to post Share on other sites More sharing options...
TehBrent Posted December 31, 2005 Posted December 31, 2005 It is a VGA system. Only one.. stock is set at VGA, so no need to change. Share this post Link to post Share on other sites More sharing options...
TehBrent Posted December 31, 2005 Posted December 31, 2005 Great help! Share this post Link to post Share on other sites More sharing options...
lowboy Posted December 31, 2005 Posted December 31, 2005 Did you follow build process as shown in sticky. What GFX card are you using as sig shows rma'ing. Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now