Jump to content

how to startup


Recommended Posts

hi, today i got my board... now the first problems.. the ps just got 20 contact ATX conector not that 24 contact.. also just a 4 contact p4 connector not that 8 contact... i do not have pciX gfx just an old pci one atm... the hdd is in the system im writing from... is it posible to boot up the system? i read that it is possible to use only tha 20contact connector.. is that true for the expert?!

Share this post


Link to post
Share on other sites

it should be true that its is possible but its not gonna be the most stable.

 

as for the 4 pin the manuak says if ur only using one gpu then the 4 pin is ok.

 

you may want to get a new psu in the long run and def before you overclock

Share this post


Link to post
Share on other sites

i had a try now, but the monitor does not startup... also the diagnostic leds are all red... do i nedd to have an pciX card or hdd installed... or does the board need another bios for an opteron?! can someone tell my the minimal hardware requirements to see everything is working?!

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...