CalvinColdstar Report post Posted December 18, 2005 Just purchased my new rig (specs in siggy) As my OCZ Platinum(TCB3 I believe) Rams have yet to arrive, i decided to use my old Kingston Value Rams (Hynix DT-D43) The prob is, when i turn on my rig, the screen is blank. The diagnostic leds stucks @ 2leds... According to the manual and my own interpretation, i assume its either the Rams or the GPU....but strangely enuff when i tested the board with my old 6600GT Pci-e, i still get the same problem...... is it that my board hates my kingston rams or is it that the board is faulty? Share this post Link to post Share on other sites
bikspk Report post Posted December 18, 2005 This may be a stupid suggestion but did you put the RAM in the correct slots? I initially put 2x512 in slot 1 and 3 and couldn't get the machine to boot but when in 2 & 4 it worked fine - the manual recommends slots 2 and 4. Share this post Link to post Share on other sites
nibean Report post Posted December 18, 2005 Do you have your 4 pin power connecter plugged into the 8 pin molex? I had to do that before my computer would boot. Share this post Link to post Share on other sites
CalvinColdstar Report post Posted December 19, 2005 all connecters are plugged in except for the floppy connector that is needed when in crossfire and also i tried using 1 stick of ram and in all 4 slots i still get the same problem Share this post Link to post Share on other sites
LoN3R Report post Posted December 19, 2005 KVR will not work in the board.. Share this post Link to post Share on other sites
CalvinColdstar Report post Posted December 19, 2005 so it means that my ocz will have a much higher chance of working on this board? i collecting them later Share this post Link to post Share on other sites
LoN3R Report post Posted December 19, 2005 ya ,kingston value ram has like 1:1000000 chance of working in a A64 dfi board Share this post Link to post Share on other sites
CalvinColdstar Report post Posted December 19, 2005 ok..i got it to work...but now when it boots...the RDX200 splash screen the color is like damn ugly..... Share this post Link to post Share on other sites
tckrto Report post Posted December 19, 2005 its normal due to x1800 series card. don worry. they will release new bios to fix this problem soon Share this post Link to post Share on other sites
CalvinColdstar Report post Posted December 19, 2005 its so ugly i had to disable the splash screen....anyways i am shocked to see my X1800XL doing 89deg idle man......using ati driver to see the temp Share this post Link to post Share on other sites
bro20000 Report post Posted January 1, 2006 I had the same problem if u have some basic ddr 400 lying around use that then in bios put the volt up to 2.9 and then save and exit and switch off and put the ocz mem in and that should sort ur problem! Share this post Link to post Share on other sites
Spires Report post Posted January 1, 2006 the latest dfi bios for the RDX200 board fixes that 16 color boot screen. Share this post Link to post Share on other sites