Jump to content
Sign in to follow this  
zungkono

DFI NF4 SLI-DR EXPERT ram's setting and problem

Recommended Posts

Dear all,

I got problem using this new motherboard, when I used the wrong setting(RAM) my comp won't POST(STUCK & 3 leds lights, the screen blank) so I can't enter BIOS. Finally I had to clear CMOS--> tried to restart-->still didn't POST-->put off the second ram(in DIMM4)-->restart again-->POST-->load opt default on BIOS&save-->then I can shutdown and plug in the second ram again-->normal boot to windows(dual ch).

 

This way is too long and because I use XP-120, it's very hard to put the second ram off. Can anyone suggest me a better way-out without putting off the second ram?

 

When I used memtest(test#5 for 2-3 hours), my ram tested in DDR500 there is a strange happened to me;

my ram twinmos speed premium utt ch-5 (p/n : AA4T) pc3200 2x256MB

I set htt muti x3, mem divider200(1:1), 2-2-2-5 1T 3.33v

if I use cpu multi x7 so many errors found

but if I set cpu multi x10 no error found

Anyone here have an experience like me?

 

Please give me a solution.

Also anyone know the good setting for utt ch-5 in DFI NF4 SLI-DR EXPERT?

THANKS.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×