Jump to content


Photo
- - - - -

memtest86 errors in Dual Channel only


  • Please log in to reply
25 replies to this topic

#25 iamkoza

iamkoza

    Geek

  • Members
  • PipPipPip
  • 808 posts

Posted 10 December 2005 - 11:59 PM

crap... lol, I'm using same RAM as plantj.... hope i don;t run into same problems...

Following ed's guide for initial setup, memtesting one stick of ram right now.... almost afraid to test the both if single ram passes 8 hr's

#26 TekWiz

TekWiz

    New Member

  • Members
  • 2 posts

Posted 26 August 2007 - 09:44 PM

Thanks for posting the memory settings. I used them when I was having trouble on my initial build.

Then about a month ago I came back from vacation, and ... dead PC. RMA'd it back to DFI and they told me my power supply that had been OK for a year and a half was incompatible. Got the board back and ordered a new Antec True Power Trio 550W. Things were good for a couple of days, then it locked up and the SATA drive would not boot due to a hard drive issue. So I thought I'll just pop in an IDE drive, install XP and fix it. No luck. File copy errors every time followed by a BSOD. It appears that DFI flashed the BIOS. After a reflash to the version you suggested, and a configuring the settings you specified, I can now install XP on the IDE drive. Took me a while to figure out what happened, but the clue was that there was no Command per Clock option and a couple of other differences in the available settings.

So, thanks again.

DK