How to clear Hellfire BIOS?

[Drizzt]

I installed Hellfire BIOS to my DFI Lanparty NFII Ultra B and tried to get better overclocking. First I decided to lower memory divider to 100MHz to see how high my motherboard will score in FSB. But now my computer isn't booting at all! I tried to clear CMOS jumper but it didn't work.

 

So how can I reset my BIOS back and get the system booting again.

 

Thanks for help.

[Clay]

Ya' gotta' to make a sig. "user-cp">"edit sig" Put in all the parts in your computer +the bios date ("Hellfire Rev2 6/19") "THEN" read this :

http://www.logan.eclipse.co.uk/dfi_ui___lpb_faq.htm That's Loggan's faq that should help ya' LOL "Clay"

[Clay]

Here's another thread might be of intrest to ya'.

http://www.dfi-street.com/forum/showthread.php?t=1467

[Drizzt]

I made the sig and read those thread/FAQ.

 

I will take the battery off for couple of hours and try so.

 

Could it be that my BIOS chip has broken?

[ex.treme]

The same things i have 2x. I must reflash bios. Is probably bad memory alpha timings.

After new bios you must set up alpha timings to auto or change at stable timing , if you dont do it, after save bios is end.

 

For example is >

100 fsb -> 8 3 3 3 - auto -auto-auto-auto-auto -auto

or i have with bh5 - 11-2-2-2-3-3-3-3-3-3

[Drizzt]

I removed the battery for night but it didn't help.

 

I think my BIOS is broken.

[phobosq]

I never considered going asynchro with mems on NF2 a good idea, had three boards and none of them worked correctly asynchro/