Jump to content
Sign in to follow this  
L337

New board, won't post.

Recommended Posts

[quote name='StephenC']Place the one stick in dimm slot 2. The orange slot closest to edge of motherboard.[/quote]

No go. Prehaps i should be more descriptive, when the board does power on, the diagnostic LED's are all on and fixed, only this doesn't happen often, usually what happens is the LEDs will go on for a split second and the fans will spin a tiny bit but afterwards does nothing, and the board will not even feign a start again until i cycle the PSU power on and off.

Share this post


Link to post
Share on other sites
Ok, check your build. Make sure nothing is shorting motherboard to case. Make sure you do not have a extra standoff. Loosen the screws securing motherboard to pan. Try the barebones approach. Connect only what is required to post (no drives or add-on cards) Disconnect/remove from motherboard and PSU). If the same, try it outside the case.

Share this post


Link to post
Share on other sites
Its out of the case. It was on the case's mobo tray but i removed it from that and now its lying ontop of its box with the static bag inbetween.

Share this post


Link to post
Share on other sites
Remove the static bag. The protection is on the inside of the bag. place it on the foam that the mobo came on. Is there anyway you can check your parts with another motherboard? Do you have a pci video card?

Share this post


Link to post
Share on other sites
All the parts exluding the video card I had working on my MSI NF3 motherboard so i know they work, its just the video card i'm not shure about. I have tried running without the video card to no avail, and unfortunately i don't have a PCI one lying around. I will go try remove the static bag.

Share this post


Link to post
Share on other sites
[quote name='raydelee']maybe u should try with another psu & see how it goes
i have the same problem sorted out with another psu[/quote]

Yeah this is my second PSU and i know they work on my other platform, but thanks all the same.

I guess i might have to RMA this because i seem to have come to a dead end.

Thanks for all your help & advice guys :)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×