N4D623-3.exe

[mpghitman]

Just updated BIOS to File N4D623-3.exe

booted it up no array so did the following

1. Flash with the new bios and when complete turn off the computer and clear cmos.

2. Power up the computer and enter bios, go to Integrated Peripherals -> Raid Config, In Raid Config set Internal Phy SATA 1-4 to enabled (and the Silicon image ones if you have the 'DR' flavour and you have your array on these channels)

4. If you have a USB keyboard enable USB Keyboard support also in Integrated Peripherals

3. Save and exit the bios

4. When prompted by the NVRaid bios screen (After POST) press F10 to enter the raid setup. If all has gone well you should see your Raid array has been detected and showing as Healthy.

5. Press Cntrl-X to exit Raid setup and your comp should boot as normal.

 

Boots up but windows will not load change in hard ware jsut keeps rebooting.

Can not boot in safe mode ??

 

Lost here any ideas.

Spec is in my sig

 

Have up=date the wrong bios should done NF4LD310.exe

 

and if so how would i be able to roll back.

[Guest Tmod]

Have up=date the wrong bios should done NF4LD310.exe

 

Do you have a floppy drive?

 

Create a bootable floppy with the flash files on it and just reflash.

 

Tmod