Jump to content

Can DFI Nf3 Ultra make tccd work @DDR600?


Recommended Posts

I have some OCZ 4800 Platinum running sweet at DDR600 as per RAM spec at 2.5-4-4-8 2T with no issue at all. In fact ive run benchmarks at 320fsb using same timings. Ive also run 1T up 285 using 2.5-4-3-8. Yet to test what timings needed to run at 300 with 1T, possibly 3.0-4-4-8. But I can confirm 300fsb hammers on this m/b.

Share this post


Link to post
Share on other sites

Some guys said it can't make tccd run @ddr600,Even if G.skill ddr600

 

 

um i got my TCCD to work at 600 mhz speeding along here

3.0Volts should do it @ 2.5-4-4-10 T1 (as u can see it shows T2 but it is running at T1 is enabled in the bios)

it OCz HIGHEND stuff :)

 

passed memtest two times

 

i had the last timeing set too 11 cause i was too lazy to put it to 10

i have an exter gig (1GB 1022MB)

500$ for it if u want to buy it from me (they now only sell the low end . TCC5 now days)<a href=sp32200501010352320qm.gif' alt='sp322005

Share this post


Link to post
Share on other sites

um i got my TCCD to work at 600 mhz speeding along here

3.0Volts should do it @ 2.5-4-4-10 T1 (as u can see it shows T2 but it is running at T1 is enabled in the bios)

it OCz HIGHEND stuff :)

 

passed memtest two times

 

i had the last timeing set too 11 cause i was too lazy to put it to 10

i have an exter gig (1GB 1022MB)

500$ for it if u want to buy it from me (they now only sell the low end . TCC5 now days):D

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...