Sli DR wont post

[Darkwolfind]

Came home from work today and booted the ol puter up. Computer wouldnt post. The diagnostic lights do its little coutdown 4-3-2-1 but on the last one stays lit up and stops at where it shows the post screen but only the first part of it. Ive tried most everything including reseting the bios and im stumped. Tried almost new everything, ram, cpu, HDD, video cards etc and everything works up untill the the screen shows the first part of the POST screen.

[punker]

what power supply do u have

[Darkwolfind]

Antec Tru Power 550, and ive never had any problems with it.

[Dynomutt]

if it gets down to 1 light then it has POSTed if it goes to no lights then the board beleives the OS is loading

 

you should be able to enter the BIOS and load optimised defaults even with 1 Red LED,

 

EDT your quite well OC'd there can you post your Genie BIOS and DRAM config settings as these will help peeps to help you

 

Have you tried Stock?

[Darkwolfind]

it starts to post then the fans spin down to low and nothing happens

[Boppo]

As asked, did you try taking it back to stock settings and see if it will boot up?

[Darkwolfind]

Yup reset the bios/cmos a few times same thing starts to post then nothing

[Boppo]

Is your array still showing up in BIOS and the array setup?

[Darkwolfind]

id say it takes about 4 secs of bootup and that is it, everything spins down to low it posts to about where it shows the proc type class speed etc and shows how much ram i have and that is it

[Dynomutt]

so it does not diplay any of your drives (they probably not being detected check jumpers on IDE drives if correct, disconnect drives and try booting to memtest, if this works then add drives 1 @ a time till you have problem again

[Darkwolfind]

this is interesting i tried a different PSU and it just gave 4 led lights and no i cant even enter the bios

[Dynomutt]

go back to your old PSU and hope it gets past 4 lights again then try disconnecting all drives optical and HDD's