Jump to content

Shadowdogg

Members
  • Content Count

    30
  • Joined

  • Last visited

About Shadowdogg

  • Rank
    New Member
  1. I don't have a RPM reading for PWM IC whatever that is. Should i have one? Its currently at 39 oC but not too sure even what it is.
  2. I really don't want to use SLI bridge as i mentioned earlier there is much stuff on my motherboard and it would proberly bump into some usb connections on the board and would mean a lot of messing around which i dont want. I would like to know what temperature the Chipset should be kept at at the minute it is 43oC.
  3. There is two ethernet connections on SLI-DR. One that is with Nvidia nForce networking connection and another Marvell Yukon 88E8001/8003/8010 connection. Which is the best to use? Also, because my gfx card is so big (7900GTX) I think it is slightly catching the fan - there is proberly little i can do but it is making a hell of a lot of noise. I make sure the chipset fan goes on full at around 50oC is around 43oC on idleish. Just wondering if there is much i can do without setting it to sli where it would create more problems over usb attachments etc. Ta P.S Thanks to all those who helped me out last time. I fixed my problem with non booting with a replacement hard drive and ram and now it works all a ok.
  4. would the: Western Digital WD2500KS Caviar SE 250GB 7200RPM SATA2/300 16MB Cache - OEM http://www.ebuyer.com/customer/products/in...oduct_uid=94403 Be compatible with my mtoherboard??
  5. I will try this tomorrow - personally i think its the drive so i have a RMA ready to go. As with the RAM i spoke to OCZ about it and went through the Memtest with each ram stick and the CAS seem to be of slightly different timings which could have contributed to it not woreking. And thanks for the help
  6. Hi, the only connection i dont have is the 4 pin drive connector and thats because i dont have any more connections from my PSU as its already in the drive itself. But surely that wouldn't affect my hard drive from working?
  7. Well i think ive done everything in the book - im gonna try and test it out on another PC to see what happens and hopefully its just the hard drive and not the entire board. Thanks for all the support
  8. Well i tried that cmos clearing with battery gone - with little success coming from it. When i enter it in sata 1-4 it doesn't even let me get past the first screen, however, when i put it in SATA 5-8 (usies the silicon image sil 3114 chip) still doesn't actually detect it or i dont know a way to install it. What i thought i had to do was press F4 on that screen and/or at windows installation install it by pressing F6 and it did nothing. :'(
  9. As you know from the other thread, it does work when i remove the Hard Drive connections but doesn't when i re-enter the Hard Drive... I am beginning to think its a faulty HD or some setting wrong. I think it did boot up with the four serial ATA ports supported by the silicon image sil 3114 chip but didnt recognise the drive.. any ideas?
  10. Hard drive problem more important at the minute though please
×
×
  • Create New...