Jump to content


  • Content Count

  • Joined

  • Last visited

Everything posted by qwerty69

  1. Hi LanceDiamond, i'm from Singapore and we have 30c ambient here thus the general higher temps. Regarding the GPU temp, i could have messed up. Was too confused yesterday because of the prime errors... It should be around 55c instead. (this is still hot but it's normal over here in Singapore) As for the hard disks, yes you are right, my case cover is off and i did observe the airflow for the hard disk area is not as good as it should be. But i don't think this should be a problem for now because HDD load temps is below 42c which is normal over here. I hope it's because of the AMD dual core driver because i didn't know it was required. Will try it later today.
  2. No i did not install the dual core driver. Is this absolutely required? Can i do it on a Win XP SP1 or do i need SP2? Sorry i'm a newbie to this.
  3. Hi pmorcos, my case is a Lian-li V2100B. Well i'm actually from Singapore and the ambient temp here is around 30c. I did up my vdimm to 2.9v but it's still the same. I also tried blowing a 50cfm 120mm fan at the NB but for some reason, it increases the temp by 1c. On the other hand, motherboard temp decrease around 2c. I will try a few different fans to bring down the temps. Thanks again.
  4. thanks Sp00nLude, yes i did install the nvidia IDE drivers. I will try uninstalling them tomorrow as it's 3am over here. Been trying to stabilise this thing for the whole day... Hmm just to clarify, is what you are refering the 'Nvidia IDE SW drivers' for RAID? Or do you mean the Nvidia PATA and SATA HDD controllers as well? If it is the Nvidia IDE SW drivers only, after removing this, can i still use Nvidia RAID?
  5. I'm building new system for my brother. Here's the spec. CPU and RAM is run at STOCK. X2 4400 Toledo DFI LP UT SLI-DR GSkill F1-4800DSU2-1GBFF (2 x 512mb) eVGA 7800GTX Hitachi 250gb x 2 Antec TrueControl 550 Lian-li V2100B Basically here is what i have done. 1. Flash bios to 0623-3. Bios setting left at default. 2. Install Windows XP (SP1) with no problems. 3. Install 6.70 nforce drivers and 81.85 vga driver. 4. Install network drivers, etc. 5. Try running Super PI 1MB. The Super PI program hangs while running halfway.....??? Tried Prime but less than 10secs got error?? Ok checked vcore, its only 1.3v+ so reboot and changed to 1.5v 6. Ok now Super PI 1MB can finish running in 39secs. 7. Try Prime and ok it runs fine for 30 mins. 8. Then tried running 2 primes without setting affinity. Straight away one Prime got error.... Tried a few more times and sometime it even gives the ILLEGAL SUMOUT error. 9. Tried giving affinity to each Prime but got the same thing... If i run 1 Prime + 1 Super PI, strange thing is Prime will run ok but Super PI will hang. The temps from everest while running 2 primes is, Motherboard 55 °C CPU 43-45 °C North Bridge 55 °C GPU 60 °C HDT722525DLA380 38 °C HDT722525DLA380 43 °C 10. Currently running 1 x Prime with no problems. I have not even started to o/c and i got this... Could it be my temps? Or is there anything i should set in bios? Really appreciate advise from the experts because i'm a total newbie to AMD and DFI mobo. :confused:
  • Create New...