Jump to content

xguy

Members
  • Content Count

    112
  • Joined

  • Last visited

About xguy

  • Rank
    Member
  1. 1. What rev do you have? dunno,I know it's a very early revision though. 2. Do you have a psu that keeps a fan running after shutdown? no 3. What PSU? PC Power and cooling 850W 4. Do you have the following issue? if you go 1. Choose Start, then select Shut Down. 2. From the pull-down menu, select "Shut Down". 3. Click OK. and then i leave it 30 sec to 1 min and press the power button once to turn the pc back on, it fires up shows me 4 leds then 3 leds then 4 again and turns off. or does your pc restart with no issue? NO issues here
  2. Does your PSU have an 8 pin power connector? are all (3) power connectors properly connected to your mobo?,
  3. MBM5 always running, but when testing benching I launch SG as well (quicker response)
  4. No you don't need the Karajan and yes 6.70 is the latest official Nforce driver GL building
  5. Do not update your bios to a beta release or else you will lose your warranty if something goes wrong, mine shipped with the 11/02 , and that's where I'm keeping it untill beta is approved.
  6. Temps are not accurate , they are way off, I don't care what anyone else says, my smart guardian reads 25C while a probe on the heat sink reads 33C . This means the CPU is 8C cooler then the heat sink? I think NOT. However it seems that load temps bring the difference closer within 3-4C. That is why I installed a probe to keep a good watch on my temps.
  7. Temps are deffenitly off on the expert, I attached a probe to the heat sink, right now IT reports 24C and the probe reports 31.5C, so yes it's not only opterons.
  8. Raising the ram voltage to 2.65 (default) solved the problem, thanks guys.What I did is saved my bios setting in bios relaoded, then set it to optimal settings, and tested it and it was fine, then I compared the changes , I first tried to set the ram voltage to the same as "optimal" with everything else same as my tweaked settings, and bam this was the culprit. thank you all for the responses
  9. what is the KillCMOS and where do i get it?
  10. I just swapped from SLI-DR to the expert, it's been a week now, the board is 100% stable (prime super pi games) except for one glitch: on cold boot it always either freezes or BSOD right when windows is loading, if I reset it will keep doing the same, unless I go into bios and save an exit without any changes , then it will load windows fine, and if I do that that immedialty on cold boot it will be fine as well, it would just not cold boot straight without going into bios first. any ideas?
  11. I have the 6600GT dual disabled, I think it is to be turned on to support dual GPU cards not for SLI, if I enable it everything goes outta wack and I lose video.all you need to do in bios is change the PCI-E configuration in the geenie bios section to the 8-1-2-8 (or something like that ) option. Mines are running fine configured as above. Make sure you check everything well (ie crads are seated well, power connectors etc....) is all I can suggest.
  12. you o not need to enable 6800gt dual card mode, leave that disabled.I did that and I got no video (black screen)
×
×
  • Create New...