Jump to content

mysterfix

Members
  • Content Count

    79
  • Joined

  • Last visited

About mysterfix

  • Rank
    Member

Contact Methods

  • Yahoo
    mysterfixer
  • ICQ
    0
  1. Yeah, there is, I'll see if I can find it for you. Edit: I found it, the vmem measure point is located at the top left corner just above the top memory slot near the NF4 stamp. http://www.dfi-street.com/forum/showpost.p...740&postcount=2
  2. You should get a DMM and check your voltage going to the memory. Check it after you make changes and check it once per day after you get the memory stable again. It sounds like your board may have a faulty reg. If the memory were bad it would show errors no matter what so that leads me to believe it could possibly be a power regulation issue. I ran into a similar issue where I was getting BSOD and such every few days. In my case it was a hardware conflict, my PATA back up drive was causing the crashes. I removed the drive and my troubles went away.
  3. So does that mean that even though the board can go to 300htt and beyond as provided for in the bios your warranty is viod the moment you go above 200htt?
  4. Thank You for answering the question Angry. I have seen the thread you speak of EdLSmith but that was not the focus of this thread. I simply wanted to get a clear answer for myself and others who were concerned about this.
  5. With all do respect I don't believe that it was answered. Yes it will void the warranty or no it won't is a much more clear cut answer.
  6. Well Mushkin covers there redline memory up to 3.5v and recommends DFI boards but that's besides the point. I just want know if using the jumper will void my warranty and if it does why is it on the board in the first place? :confused: I have some redline on the way and this really makes me nervous. How can you refuse an RMA if the voltage options (jumper) are provided by the manufacturer and the memory in question is spec'd to require the extra voltage? Even if the memory is not spec'd for extra voltage the board should still be covered by warranty if the jumper which is provided by the manufacturer happens to kill the board while in uses.
  7. I recently read on another forum that some people have been refused RMA because they used the 4v jumper and it somehow killed there board. I think it sounds like a bunch of bull but I figured I'd ask anyway for clarification. Is there a problem with the jumper? Mine seems to work fine, I've tested it up to 3.8v without incident.
  8. Try reinstalling your usb drivers. I had that happen to me when I tried to update my chipset drivers. They may have been uninstalled somehow or corrupted.
  9. The yellow slots seemed to be good for me up to 250mhz. You should definitly try the orange slots, I was always able to boot at 300mhz and beyond on the orange slots.
  10. Sweet, I can't waite to get mine. ( 2 more weeks )
  11. You should try for 2.9 that chip should be able to get close to 3ghz with around 1.5v :nod:
  12. I think eWiz has them and you could also try zip zoom fly.
  13. Agreed on the memory thing I just got some CH-5 chips and I have them up to 230mhz 2 2 2 5 1T so far. Gonna go for more in just a few here. :drool:
  14. They've always worked fine for me but others will say no, don't use them. Try it for a little while and see if you like it. Run some benches and games to see if your system is better or worse with the .5 multi.
  15. Very nice, I can't waite to get mine I may have to throw the vinnie in my NF3 Ultra-D and put the OP in my new board.(I got an NF4 SLI-DR in the works :nod: )
×
×
  • Create New...