Jump to content


Perscitus

Member Since 09 May 2007
Offline Last Active Dec 06 2017 01:34 PM
-----

Posts I've Made

In Topic: Refining my overclocked i5-2500k

06 December 2017 - 01:24 PM

Ended up taking it down to 4.4 and set the offset to +0.015V. Didn't have a lot of time to much yesterday since I had to install the GTX 1060. Everything is playing nice and smooth, so I might take the lazy approach and leave it as is.. but I'll continue to monitor my temps and such to see what my normal use pushes them to. 


In Topic: Refining my overclocked i5-2500k

04 December 2017 - 08:09 AM

Tonight I'll probably reduce the offset to +0.010V and see what temps I get from Prime95 torture.. and if they are OK, I'll give it an hour on Prime to see if any crash occurs. If there is an issue, I think I'll just start dialing back the multiplier. As mentioned, the difference it makes for my frames in game are minimal.. Shame I'm stuck at work an unable to test now......


In Topic: Refining my overclocked i5-2500k

03 December 2017 - 10:53 PM

I ran some games and such during the days and peaked out at 79°C. Should be OK, I'll keep an eye on it and if needed drop the voltage and/multiplier. My video card will provide the more noticeable difference when I am gaming, so I'm not worried about dialing back the OC a bit.


In Topic: Refining my overclocked i5-2500k

03 December 2017 - 07:31 AM

I left it overnight, and my temps from the idle are lower-mid 30s(°C). So that is fine. I'll play some games with the HWmonitor on and see where they peak out. With Prime I stopped it after it touched 90°C and it took about 7 min to reach that temp. As mentioned, I doubt anything I do in my daily use will get the temps near the Prime95 values. My usage is pretty much gaming, browsing, and MS Office crap.

 

Regardless, I will reduce my offset a little and see if I can stay stable.


In Topic: New Keyboard to replace my 20yr old dinosaur

02 December 2017 - 08:33 AM

@AkakmanH Thanks. I was impatient so I just went and bought a Logitech G810 RBG. I read a dozen articles on the switches and boards, so I based it off of that.... Hopefully it works out.