Hey guys where do people get these half cases or case extension boxes such as this one...

that looks like it was cut from the bottom half of an identical case... I know Lian Li do them as housings for the Vapochill LS (for LL cases)

if you want a case that size, how about going for a full tower? I could fit triple rads on the side at the top of mine...

that looks tight. But yeah, looks like it's the bottom half of the top case, flipped upside down.

What case do you have? I was looking at mountainmods cases they are nice. It looks to me like most all the full tower cases dimensions are about the same as what I have with the P180B, I will just have to make it fit!

just get a motzart TX from TT... darn thing can pass as a phone booth

Clearly you've never seen a CM Stacker or Thermaltake Armor!

Yes I have and the stacker is 23"x 9"x 21.2" (DxWxH) the P180B is 21.3" x 8.1" x 19.9" (H x W x D) so there is not that much difference. The Armour is 20.87" x 8.66" x 22.05" (H x W xD).

It's the interior design that matters. A Stacker can fit a PA120.3 with fans along the top or bottom and still have enough room for everything else. Whereas the P180 has all that compartment stuff. I refer, of course, to the original CM Stacker.

My full tower is taller

Chieftec Mesh Bigtower

470mm x 205mm x 652mm*
*= incl. feet (without -18mm)

18.5" D x 8.1" W x 25.7" H
18.5" D x 8.1" W x 25.0" H (without feet)

The Mountain Mods and Yeong Yang cube type cases would be nice for watercooling... I'd probably mod a YY case rather than spend $$$s on a pre-mod MM case

Mine is the same size as well, then again its just the non-branded Chenming variant...

Chenmig = Chieftec

Check out Xoxide. They have lots of that stuff. Try FrozenCPU.