Hey guys

im looking for a big case to fit water cooling. with my mobo the second GFx's card is right @ the bottem of the case and the. And the cooling for the gfx cards has an outlet @ the bottem








i was looking @ this case (Lian Li PC-V2100B) Case but im not sure if the pipe would kink with the bend. I could change the water block so the outlet does not come out of the bottem. or i can get a ATX case with a large space below the mobo. i would have lots of space for the rads and pumps in that case but im not sure about the pipe kinking. what sort of case would you go for?





Thanks firky

that case would not help AT ALL

the motheboard is upside down, so your graphics card would be right up near the "roof" of the case

you need a case with room on that side of the motherboard area... this will probably mean a full tower with the option of putting the power supply in either location (or both)

here's the layout inside another lian li case:


http://www.lian-li.com/product/product06.p...ex=8&type=b



notice the motherboard screw locations, the psu, and the space above AND below the motherboard area... this type of case is what you should be looking for

yeah i under stand that case is btx and the mobo is the other way up but it has loads of space if only the mobo was the other way up =/


but i guess this is what u mean. Lian Li PC-G70 only bad thing is it looks ugly lol on the out side!





LOL u just beat me too it!!!!