I want to make a new exterion for my computer (again).
this time i'm going to make aluminum sides and top.
I need an easy detailed description on the different options I have to attach a sidepanel easely.
I'm always strugeling with that.
I was planning on using my old frame so I'm limited in that.
I want it to hold well during transportation.
I don't have any equipment to solder (or any other type of connecting diferent parts except for screw)


I also need some information on what kind of tubbing I would need for a windown,
and how I have to cut it.
these little thing are ofter not described in how-tos, but tell me in you have one.

I have a good fealing about this, so I hope it turns out well.

thanks

First you must have your window. You can buy them in kits or make your own. I suggest using Perspex.

Use masking tape to cover the case on the front and back.

Next get a washer that has a difference of 5mm between the inner and outer edges. Lie the window in place on the case, and then take the washer and lie it against the edge of the window. Put the tip of your pencil in the the middle of the washer and use it to draw a line 5mm larger than the windows perimeter.

If you use either of the window molding you can see AT THIS PAGE, you just have to Line it around the window opening that you have cut with your Dremel, with the smaller of the two gaps against the case edge. If you're using a rectangular or regular shaped window, the join usually looks best on the bottom or the opening.

Trim the excess molding so that it fits snugly.

Taking one corner of the window and inserting it into the slot in the molding, slowly work your way around the window, working it into the slot. Then insert the locking strip into the last remaining slot, and you're done.

but will that hold if he wants to take it somewhere if that window comes out it takes forever to getback in