i was running occt and saw the graphs. i wasnt too happy with what i saw. take a look should i change. i just got a 535 enermax that seens better. its cooler and has 24 pin atx sli pcie ready. i just read about ravens issue but i think hes just unlucky. i had a enermax 350 and always ran good for me.

Measure it with a multimeter, software isn't accurate.

how can i measure vcore and 3.3 volts? i know 12 and 5v from the molexes but what about during tests?

i think the 3.3 comes from the 20/24 pin molex. i havent tested the 3.3v myself, feels risky. the 5v one and 12v are safe for me.

PSU FAQ

I agree with comments above. Never trust software measurments for voltages, temps, etc. Use a DMM to get your voltages. and if you are too lazy to go to the PSU FAQ that the psu guru(lol) linked to then I will tell you to measure the +3.3v all you have to do is put the red probe into any wire whole on the 20/24pin connecter with an orange wire in it as the orange wire is the +3.3v

hehe i know how to do it, just that my neo2 which is 20pin is using a 24pin psu and the cable is easy to pull out.