Basically I have the case that's actually reviewed here.

What I'm pondering, though, is what the best way to remove the fan that's on the back. Instead of being screwed in, it's anchored on, is the phrase I think the reviewer uses.





What would the best way be to get this fan out of the system so that I can install a different one?

Modding cases isn't particularly a forte of mine, so I'm not really sure if there's an obvious way to do it that I'm missing or if I'll have to cut it out.

Thanks for the help.

what are those pop rivets or little plastic pegs? If they're rivets drill them out with a small bit. If theyre plastic pegs and you dont plan on using them again...break the suckers off.

EDIT: i guess plastic pegs, just break/cut them off and use screws for your next fan.

you can pull those plastic pegs out either with your fingernails or pliers or a blunt knife...

On the back side of them push on the little post in the middle. it will pop the center out enough to pull it the rest of the way out. You can reassemble them if you want but I just used screws on my case.

Fantastic. Thanks a lot.