how do you remove the pins from a m0b0 connector?

I couldnt do it with a paperclip, you should try using one of those ATX removal tools. I needed to apply a lot of pressure on the inside of the connector where the pins are, then they slid out. They arnt meant to come out so trust me it takes some getting used to. You will have to fiddle with it for probably 20 mins just to get the nack of it. I hated removing ATX pins Good luck

i could always do it with a needle, but you've got one of those pin extractors now, so use it

Be a man! Chew it off Why else would we have been given teeth?

Lolll markiemrboo

The easiest way is the tool but if your budget is tight needles work good enough.
i did one once with seringe needles flattened and the point cut off.
the main thing is to get something small and flat into the side of the pin (both sides)at the same time
Tool cheap, and that's in CDN money,(US is $15.04) they ship anywhere
http://www.adpmods.com/case-modding/produc...&cat=164&page=1