Hey all!
have you ever tried to sleve your PSU but discovered you need a male and female molex pin extractor to do the job? well I did only problem was I didn't have either of these tools so I decided to make them using just a couple of pens and some model glue tips visit my web site to find out how I did it ,takes about 15 minutes and saves you some money to boot ...enjoy

http://www.geocities.com/v00d003/TheMighty...l?1096073809698

The web site you are trying to access has exceeded its allocated data transfer...sry dude

I had a thread about this a few months ago, it works quite well, I used it to sleeve my cables

site should be up again soon I''ll try to post a pic for ya

the site is up, might need this soon

cool ...they work really well if you follow my instructions and because the tips are all plastic you don't have to worry about damaging the metal pins ; )

And for the 20pin molex,
if you can get access to these (of course DONT TAKE THEM ON THE STREET) just cut the point off and squeeze the shaft flat with a pair of needle nose pliers (those without theet to keep the shaft nice and flat.)
Two of those will sweep your troubles away at no cost, just push the pin in as far as you can, insert the flat S/S shaft in the molex pin hole on both sides till you reach the bottom and pull the pin out.It comes out as if it was never attached