Hello guys:

I am eager to mod my case so it has a window in it. It will be my first mod, so I'm a little reluctant to do it. I have a antec performance II series case, heres the link to it:
http://www.newegg.com/app/viewProductDesc....-129-120&depa=1

I was wondering how hard it would be to cut a hole in the side of this sucker. It's made out of thick 1mm steel, and the only tool I have is a dremel. Should I do it w/ just a dremel, or not? Also, I d o not know which bit # is the reinforced cutting wheel. Thanks for the help.

i have the same case used a dremel to cut the bad boy open

Alright, rock on man! Did you do a design in it or what? ANd what techniques did you use? My dremel is mildly old also...

What bit(s) did you use?

critter check this out it might help you a bit Guide

Thanks bishop: helps a lot.

I've got another question: How could I get the plexiglass mounted around the handle? Can I cut plexiglass w/ a dremel?

yeah a dremel will cut plexi but i am not sure which cutter to use just ask your local hardware store or whereever you buy you dremel stuff

Thanks for the help and moral support guys! I just finished the projects not 10 minutes ago and it looks great! Any more suggestions for my case?

wire management is needed in that box lol

and good job on the project it looks good

I have almost that same case (chieftec) and it took me forever to cut a 120mm blowhole in the top. I don't know if I was using the wrong wheels or what but thank god I had my glasses on cause I kept getting hit in the face when I broke the wheels (about 8 lol)

you applying way too much pressure on the wheels , that will cause them to break and as for critter... 2 words, wire management