Im using DFI LanParty Ultra-D with my p180 case. I never had my reset connector hooked up(at this time my power led was working) so i opened up the case disconnected all the connectors reconnected them and my reset is now working. But now i have followed the book and even connected them in a different spot but i cant get my Power led and my HDD-Leds to work which never have anyways. Any ideas...?

turn the plugs over.

Flipped them but noticed its either constantly blinking or off(never solid), even if im not touching pc. You meant turn over as in flipping them around instead of actually putting them in upside down with wire touching entrance to connector right ?
I hooked up HDD-Led2, would i need to connect hdd led1 insteador just leave those disconnected.
Could i hook hdd-led to the speaker connectors right by them, what type of connectors is that used for anyways.
Finnaly is hdd-led 2 referring to the HD plugged in Sata Port2 ?
thanks for reply.

LEDs only work with a positive voltage applied to them; not a negative voltage. turning the connector "upside down" (actually making it right side up) would solve the problem. If it's blinking that's because the MB is sending a pulsed signal (generally the case for the HDD LED anyways).

The HDD led will blink for all HDD activity. You have to put them exactly as is says in the mobo manual. You might just have a lot of hard drive activity because your only using one HDD too