Someguy333
Mar 27 2007, 04:56 PM
I just measured my voltages on my PSU using a multimeter.
My 3.3v and 5v were ok, I'm pretty sure. Going from 3.40-3.42 and 5.10-5.12. That's through idle and load.
my 12v is a little more, at load was 12.07-12.10 and at idle was 12.16-12.17.
It also moved from as low as 12.05 to as high as 12.18, those came when I started to shutdown.
Basically I don't know if these are reliable enough. I just switched to an Opty 165 and I'm starting to OC it. Everything else is still as listed in my sig.
Polizei
Mar 27 2007, 05:46 PM
My Antec has loose tolerances and its at 5%... yours are not even 2% off. They are well within spec... dont worry.
Someguy333
Mar 27 2007, 07:28 PM
Ok, thanks
I don't really like the idea of damaging any of my components.
davidhammock200
Mar 29 2007, 01:49 PM
(Someguy333;714633)
I just measured my voltages on my PSU using a multimeter.
My 3.3v and 5v were ok, I'm pretty sure. Going from 3.40-3.42 and 5.10-5.12. That's through idle and load.
my 12v is a little more, at load was 12.07-12.10 and at idle was 12.16-12.17.
It also moved from as low as 12.05 to as high as 12.18, those came when I started to shutdown.
Basically I don't know if these are reliable enough. I just switched to an Opty 165 and I'm starting to OC it. Everything else is still as listed in my sig.
No worries here. :angel: