I'm designing a custom case and want to have 4 LED's each controlled by it's own toggle switch. I'm planning on using these LED's from Radioshack. I'm not sure how this needs to be wired.

Any help is greatly appreciated!

Aight I included a drawing for you.. I hope this helps.. BTW: dope looking LEDS

lol... it's been a long tie since we were graced with the skillz of psywar's drawings.

Gotta love them!

Anyway, Psywar is right on the money about the set up and the look of the LEDs.

Oh by the way my man, you can run all the LEDs off the same molex connector, actually what I do is make a circuit board and brong my power to my circuit board then put in my switches, resistors and LEDs.

Forget it, I didn't read the original post right and can't see how to delete a post.