Hey yeall. I just got around to taking some pics of my case. About a month ago i decided to sleeve my power cables and organize things a bit, and now that i got my motherboard back i decided to take some new pics and post em here.

What do you guys think? Do ya think i organized my cables well enough? Please leave any opinions you have. I want to hear em.







Heres what the old way looked like

definately a lot better. I like the wrap. Have you seen my mess b4 and after. I have a mid-tower so not so much room as yours.
http://forums.overclockersclub.com/index.p...opic=11511&st=0
cleanup is on 2nd page. I couldn't see anything

Wow dude, yours made quite a drastic transformation. That thing was a mess!! But good job clening it up.

I like how my case looks now, but i still feel like its missing something..... hmmmm.....



p.s. notice the overclockersclub case badge

congrats both of yall nice transformation

Slap some more fans on your acrilique. put some near the ram and processor.

I couldnt even see the occ badge it like blended in with your case
But very nice. My computer looks like a bird's nest..
But it works so im happy.

Quote ''I like how my case looks now, but i still feel like its missing something..... hmmmm.....

I'd sleeve the still loose wires with something small and chrome.
Chrome looks good

Nice - I did the same thing (used duct tape as the sleeving) and I thought I might mention that your ram is in BANK 0 SLOT 0 and in BANK 1 SLOT 0 - if you want to run Dual-channel put the other stick (asuming they have the same timings or you are willing to overclock/underclock) (the one in BANK 0) into BANK 1 SLOT 1

Kevin, if you look again youll notice i have 2 of the same type of ram in slots 1 and 3 and a different type in slot 2. I didnt think it would work, but the bios is telling me its in dual channel mode, so ill believe it.

kobalt. Small and chrome huh? What do you suggest, i wanted to sleeve the small wires but havent had the time lately. What do you think i should use that looks chromish for the smaller wires?

populating all 3 dimms on nf2 boards runs them in dual mode. slots 1 and 2 only populated runs it in single 1-3 or 2-3 runs daul channel

Didnt we already establish this. Buth thx anyway

All I do is hide most of the cables behind the motherboard tray and right side panel.

My Pics

Very nicely done gentlemen!
FxXP, I see you got a controller for that Tornado, how does it perform at varying speeds?

Runs like a charm, can control it between 2600 - 5900 RPM. I run it 3700 RPM and it keeps the CPU load @ 45C. Up'ing to a V11 soon then I'll slap the Tornado on that. (I think we should PM before we ruin the topic).

not bad. i still say it could be a bit neater. tucking the wires behind your racks would look better. =) but huge improvement from before. did you see a temperature drop?

Nothing to major. Probably about two or three degrees

<------- 4 degree drop for me....

awesome. 3 degrees is 3 degrees. good job!