New Member
Posted 24 January 2013 - 05:02 AM
As stated above. PSU was tested and works fine. Everything was working fine until I cleared the CMOS following the instructions in the manual. Everythng is connected correctly and the jumper is in the right place. Removing the batter did not help either. System shows no signs of life. Nothing happens when power is pressed. Mouse and keyboard light up momentarily when power cable is plugged in.
Any ideas?
i5-3570K
16GB Crucial Ram.
Thanks!
Member
Posted 24 January 2013 - 06:39 AM
Does the board have a button or a jumper to reset the bios?
Check to see if the button is stuck, or press it again. Might be that you pressed it and it stayed on and you might have to press it again to turn it off. If its a jumper did you check to see if it was put back in the right place.
All four rigs under water
Primary Rig -i5 2600K @ 4.2Ghz -Asus Maximus IV Gene-Z -Mushkin Redline ddr3 8Gb -MSI Twin Frozr II GTX 580 in SLI -Silverstone 1200W
Secondary Rig -i5 2500K @ 4.2Ghz -Asus Maximus IV Gene-Z -Mushkin Blackline ddr3 8Gb -EVGA Superclock GTX 560TI in SLI -Silverstone 850w
Third Rig -i7 950 @4.2GHz -Asus Rampage 3 extreme -Mushkin Ridgeback ddr3 12Gb -4 GTX 8800 Ultra -Silverstone 1500W
Fourth Rig -i5 2500K @ 4.2Ghz -ASRock Z77E Mini ITX -Mushkin Redline ddr3 8Gb -EVGA 670 FTW -Silverstone 800w
I dont fail. I just succeed at finding out what doesn't work.
New Member
Posted 24 January 2013 - 02:54 PM
Does the board have a button or a jumper to reset the bios?
Check to see if the button is stuck, or press it again. Might be that you pressed it and it stayed on and you might have to press it again to turn it off. If its a jumper did you check to see if it was put back in the right place.
Thanks!!! The Button was stuck in the pressed position.
Thanks again!
Frank <3 Reesa
Posted 24 January 2013 - 02:56 PM
That happens sometimes glad you fixed it!
BMG FTW!!
Posted 25 January 2013 - 07:44 AM
Does the board have a button or a jumper to reset the bios?
Check to see if the button is stuck, or press it again. Might be that you pressed it and it stayed on and you might have to press it again to turn it off. If its a jumper did you check to see if it was put back in the right place.
Thanks!!! The Button was stuck in the pressed position.
Thanks again!
A piece of advice: Always check the position of button or jumper (whatever you use) before powering up the PC again after every reset.
