Jump to content


Photo
- - - - -

Q6600 Overclocking


  • Please log in to reply
17 replies to this topic

#13 John_again

John_again

    Member

  • Members
  • PipPip
  • 61 posts

Posted 06 April 2012 - 04:36 AM

Well, im not sure how to take a screenshot in bios, but i took some photos! (Since i didnt ever need that again before!)
Hope these will help!
IMG_20120406_152404.jpg
IMG_20120406_152421.jpg

And this one is from HWmonitor

IMG_20120406_152512.jpg
Posted Image

#14 John_again

John_again

    Member

  • Members
  • PipPip
  • 61 posts

Posted 06 April 2012 - 09:11 AM

I also tried reducing the voltage to 1.464V as CPU-Z says, but then i run prime95 but the 1st worker stopped as soon as i started the test! The PC Though stayed awake... No blue screen!
Posted Image

#15 ARandomOWL

ARandomOWL

    Wise Owl

  • FW Team Member
  • PipPipPipPip
  • 1441 posts
  • Gender:Male
  • Location:Manchester, UK

Posted 06 April 2012 - 09:51 AM

Your northbridge voltage is way too high for the FSB and RAM speed you are running. It shouldn't need to be anything above 1.3V.

Also I doubt your VTT (FSB termination) need be that high. Did you test it or just set an arbitrary value?
2600K @ 5.15GHz, 1.52V
Maximus IV Extreme
GTX 560 DCII TOP
EK Supreme HF + PA120.2

#16 Waco

Waco

    Lab Rat 2

  • Reviewer
  • PipPipPipPipPipPipPipPip
  • 15204 posts
  • Gender:Male
  • Location:Los Alamos, NM

Posted 06 April 2012 - 10:41 AM

Yeah that does seem quite high on the NB.

Posted Image

Booyah.


#17 John_again

John_again

    Member

  • Members
  • PipPip
  • 61 posts

Posted 07 April 2012 - 06:51 AM

I tested it! But it wont boot if i wont set these voltages so high! Now i only managed to get the vcore at 1.5V, and it seems stable! at least my temps are not so high! Wont go higher than 58C...
Posted Image

#18 gunther1911

gunther1911

    New Member

  • Members
  • 1 posts

Posted 03 September 2012 - 11:54 PM

I am a noobie @ ocing and i just wanna say that you guys are awesome with all your information! This is my first build (specs are entered below) and im getting 3.4ghz. under load (intel burn test at maximum for 8 hrs.) without ever going over 58c.And my cpu-v is 1.35v Thanks for all the info and God bless. motherboard-ga-ep45-ud3p, cpu- intel q6600, cooler master hyper 212 plus, gpu-zotac gt 440, case- antec 600 v2, memory-2x4gb kingston ddr2, hdd- sata 500gb seagate barracuda 7200, 4x 120mm fans antec 3 speed, 1x 240mm antec 3 speed fan, optical drive-hp-bd240, psu-kentec 750w gaming.

Edited by gunther1911, 03 September 2012 - 11:56 PM.