Jump to content

AceGoober

Members
  • Posts

    24
  • Joined

  • Last visited

Gaming

  • Steam
    AceGoober

OCC

  • Computer Specs
    Asus P5E Deluxe <> Intel Xeon X3350
    Corsair Dominator PC8888 <> 9600GT
    2 x WD Raptor X 150 <> 1 x WD Raptor 150MB
    New 3 Loop Water Cooling Setup coming soon!
    Thermaltake Toughpower 1200

AceGoober's Achievements

Newbie

Newbie (1/14)

  1. Bump for me! Items being shipped out to people, including Angry, this week.
  2. Sure you do Angry, sure you do. Added more DDR2 RAM.
  3. You are next in line. Still might trade you for it so I have an extra one lying around.
  4. Hit me up with a PM with model and specs.
  5. Hey Doc, I have a 1GB stick of Kingston KVR333X64C25/1G, DDR-333 if you are interested.
  6. Yes, clearing the CMOS should reset the BIOS back to factory defaults. Try leaving the clear CMOS jumper in the 2-3 position for 15 minutes and see if that allows the board to boot.
  7. RDRAM (RAMBUS) and DDR are two different types of RAM, as Thewacokid explained. DDR-SDRAM can have 1, 2, 3 or 4 modules installed. To get dual-channel performance they must be installed in pairs. RDRAM on the other hand must be installed in pairs, period. Any pair of slots that doesn't have RDRAM installed into it must be populated with terminators. The terminators function similarly to SCSI cable terminators as they basically tell the computer where the chain ends.
  8. Shouldn't have to reset the BIOS from changing power supplies unless the BIOS got corrupted from the PSU failure.
  9. Hello Everyone! Three hard drives have been replaced by larger capacity drives. These are bare drives only. Shipping will be via UPS Ground unless trader specifies an alternate preferred method of shipment. To reinterate, these drives are Only For Trade or Trade Plus Cash either way. If you have something to trade that is not in the list of things I am looking for, please PM me anyways. I'm a certified hardware junkie and might work something out with you anyways. What I am Currently Looking for: Thanks for looking!
  10. I felt that more description was needed to what each area's machinery and employees do. There just didn't seem to be enough explanation to go along with each photo. Otherwise, you did a fine job.
×
×
  • Create New...