batman123

And, I'm back Problem again, i was monitoring the mutiplier value with the CPU-Z and it's very instable, changing betwen 6 and 7,5 a lot of times. Is this normal? What can be causing this? Edit: Forget it, i just disabled some clock auto control configuration and everythings goes good

Well, I'll try to find good prices on April, cause i need buy all this and a Notebook with less than 1000$. Where ? The cheaper i found was 200 ! Let me ask you more thing, is my English that bad?

The shipping would be more expansive than the processors, I'm from Brazil I have and P4 3.0Ghz here, so I'll try to have some fun with it, while I don't buy some new Hardware. By the way, on April my Sister is going to bring me some Hardware from NY, do you have any suggestion for good and not to expensive MOBO, Processor and VGA? PLease something better for O.C haha

No way to get the FSB higher than 341... The only thing i did is to get DRAM on 1364MHz Thanks for your attention.

Well, after some research, it's true that with G41 chipset i can't get high FSB? On my, the max i can get is 341, but I find some people that get 365, and this affirmation :"You to to high PCI-E and do more things" Can you help me on this? I can put what Value to PCI-E? Actually it's on Auto. My VGA is Asus Geforce 9600GSO.

hahaha nice triple post. I'm running a Intel Core 2 Quad Q8300 (Yeah it's bad but hardware in Brazil is too expensive ) One more thing, one Defaults, i have the option of Optimal defaults, on VGA I can choose Extreme defaults, Turbo.... Should i use any of this or just use the Normal Default? Well, wait for your help about this

Thanks for your attention Braegnok, thats right, the memory Clock goes up when i increase CPU Bus Speed. But what is better, Higher core speed with High multiplier and low Bus Speed, ou Lower Core speed with low multiplier and high bus speed? Annd let me ask you one more question, I modified a lot of values when trying to get RAM hight frenquency, should i get it back to defaults? Or just modify something, take a look please: Thanks again. Edit: After some tries, i got the conclusion that i can choose between 3 values for multiplier: 6, 7 or 7,5. With any of this values, the max I can put in Bus is 340, more than 340 i got boot failure. What causes the boot failure? Something I can do to get BUS higher without getting boot failure? Maybe changing voltage?

Hello, I'm a noob on RAM O.C so i need some help. I have a 2x 4Gb 1600Mhz Vengeance on a Gigabyte G41MT-S2P. By MOBO specifications i got that the maximum Frenquency of RAM is 1333 if Overclocked. I downloaded CPU-Z and i see on the RAM tab, this informations: DRAM Frequency: 533.3Mhz FSB:DRAM : 5:8 CL: 9 tRCD: 9 tRP: 9 tRAS: 24 tRFC: 127 CR: 2T There is anyway to increase the memory Performance? I tryed to change the MCH to 333 (The maximum i can) and than i got 2 option on SPD, 3,0B ou 3,6B... I did 3,6B but the CPU-Z tells me the DRAM frenquency stills the same. Any suggestion? Thanks