Jump to content

ASRock Z77 Extreme4 won't power on after CMOS clear


Recommended Posts

As stated above. PSU was tested and works fine. Everything was working fine until I cleared the CMOS following the instructions in the manual. Everythng is connected correctly and the jumper is in the right place. Removing the batter did not help either. System shows no signs of life. Nothing happens when power is pressed. Mouse and keyboard light up momentarily when power cable is plugged in.
Any ideas?
i5-3570K
16GB Crucial Ram.

Thanks!

Share this post


Link to post
Share on other sites

Does the board have a button or a jumper to reset the bios?    

 

  Check to see if the button is stuck, or press it again.  Might be that you pressed it and it stayed on and you might have to press it again to turn it off.   If its a jumper did you check to see if it was put back in the right place.

Share this post


Link to post
Share on other sites

Does the board have a button or a jumper to reset the bios?    

 

  Check to see if the button is stuck, or press it again.  Might be that you pressed it and it stayed on and you might have to press it again to turn it off.   If its a jumper did you check to see if it was put back in the right place.

Thanks!!! The Button was stuck in the pressed position.

Thanks again!

Share this post


Link to post
Share on other sites

 

Does the board have a button or a jumper to reset the bios?    

 

  Check to see if the button is stuck, or press it again.  Might be that you pressed it and it stayed on and you might have to press it again to turn it off.   If its a jumper did you check to see if it was put back in the right place.

Thanks!!! The Button was stuck in the pressed position.

Thanks again!

 

 A piece of advice: Always check the position of button or jumper (whatever you use) before powering up the PC again after every reset.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×
×
  • Create New...