Jump to content

ebm666

Members
  • Posts

    8
  • Joined

  • Last visited

ebm666's Achievements

Newbie

Newbie (1/14)

  1. If you remove the pad towards the back of the mouse on the bottom there is a screw underneath it. Remove the screw then carefully, remove the bottom its kind of hooked in on the front be careful not to break the tabs
  2. Here are a couple click and I'm using the air tool oil from Home depot but autopart stores should have it.
  3. I looked at your pic that plug is not for the oil, you put the oil in the air supply inlet and you use about 8 drops for normal use.
  4. You oil them daily if you dont have an inline oiler and you use air tool oil. if you cant find that you can use transmission fluid.
  5. sdy284 that a mercury? Close enough I guess, Its a 50 ford But I did a 6in. chop on it
  6. Here's the next one and this is my car
  7. Why don't you check for a club, I'm sure there's something
  8. and if you go around licking ram, you deserve whatever you get.
  9. He said they had pepsi spilled on them, that's pretty specific. Sound's like he's the one that spilled pepsi on them, and if they work, what's the big deal. I would be pissed if I was you also.
  10. Don't forget you'll need the computers and wiring harness from the eclipse.
  11. I have one of those, it's a complete joke. Right out of the box the shaft was bent so the bits would wobble. On top of that it had no power, you could stop it from spinning with you fingers. Look for sales, I got my Dremel 275 for 29 bucks at walmart.
  12. Just to make you laugh, I was dating this chick a while back and they had some type of Afican goat or something like that. I swear this really true but her brother tried to miked it for a couple of days before her dad told him it was a male. To this day if I run into him I have to turn the other way because I just start laughing. How could you be that dumb?
×
×
  • Create New...