Hyper Posted April 6, 2012 Posted April 6, 2012 If I'm looking at the picture correctly your want shoud be the normal operation of a psu.. check the flow with a tissue.. (the side the pulls the tissue to the fan/vent is the intake) Share this post Link to post Share on other sites More sharing options...
sword_fish Posted April 6, 2012 Posted April 6, 2012 (edited) I'm wondering if it's alright to turn the fan around and make it blow air through it to the outside of the case, instead of pulling air through the back and out into the case. Check the second picture if you're unsure what I'm getting at. Also forgive my poor paint skills most PSUs afaik are equipped with their fans as intake at the bottom then pushes hot air outside at the back. your sketch at the right which i preferred, but mount the PSU with it's fan at the bottom instead. pulling cool air from the outside then pushes hot air outside, makes your PSU running much cooler & happier by doing so Edited April 6, 2012 by sword_fish Share this post Link to post Share on other sites More sharing options...
d6bmg Posted April 7, 2012 Posted April 7, 2012 That would reduce the PSU life span wouldn't it? You'd just open your PSU which can be dangerous and turn the fan... somebody might know how... could mod the case so you make a little tunnel for the PSU air... As a matter of fact, PSU fans are intake fan. If there is no way by which air can come out of PSU, there is no use of that fan running. Share this post Link to post Share on other sites More sharing options...
Drdeath Posted April 10, 2012 Posted April 10, 2012 (edited) The CPU cannot physically be below your room ambients. It is impossible unless your using chiiled water or some form of exotic cooling. Your sensors are bad, plain and simple. Edited April 10, 2012 by Drdeath Share this post Link to post Share on other sites More sharing options...
Rofltroll Posted April 13, 2012 Posted April 13, 2012 The CPU cannot physically be below your room ambients. It is impossible unless your using chiiled water or some form of exotic cooling. Your sensors are bad, plain and simple. Either that or he's confusing celsius with fahrenheit and he's actually from alaska Share this post Link to post Share on other sites More sharing options...
Nerm Posted April 21, 2012 Posted April 21, 2012 Just an FYI: It is quite possible to get a CPU temp below the rooms ambient temps even without extreme cooling like phase, DICE, LN2, etc. For those of you that say it cannot be done you must not have been around when I was doing WR breaking stock/air cooling experiments on the Athlon barton core. Also as others mentioned anytime going below ambient is dangerous as to condensation issues, however with that said I have had several chips/boards completely frosted. Would warm up and drip all over board and CPU and of all those times only damaged one board and one CPU. So even though condensation can cause problems it is not the pcb killer some think it is. Share this post Link to post Share on other sites More sharing options...
ir_cow Posted April 21, 2012 Posted April 21, 2012 (edited) i honestly did not know you could get below ambient temps with air cooling. this would be the first. think about it, air is room temp, it moves across a heatsink which is dissipating heat, how is it possible to get below the temp of the air? Edited April 21, 2012 by hornybluecow Share this post Link to post Share on other sites More sharing options...
Nerm Posted April 21, 2012 Posted April 21, 2012 i honestly did not know you could get below ambient temps with air cooling. this would be the first. think about it, air is room temp, it moves across a heatsink which is dissipating heat, how is it possible to get below the temp of the air? It is kind of cheating but you make the air source into the case colder than the rooms ambient. Picture in your mind a 10,000BTU window A/C unit, 4" dryer duct, and duct tape. Share this post Link to post Share on other sites More sharing options...
Drdeath Posted April 21, 2012 Posted April 21, 2012 The ONLY way to get a CPU below ambient temps is by using a source that uses colder air(or water) then the ambients. It is a phsycal certainty it cannot happen, not a theory. Share this post Link to post Share on other sites More sharing options...
Nerm Posted April 21, 2012 Posted April 21, 2012 The ONLY way to get a CPU below ambient temps is by using a source that uses colder air(or water) then the ambients. It is a phsycal certainty it cannot happen, not a theory. Yes, and using a colder source while still using air cooling is possible. Share this post Link to post Share on other sites More sharing options...
Waco Posted April 21, 2012 Posted April 21, 2012 Yes, and using a colder source while still using air cooling is possible. Which really doesn't qualify as "regular" air cooling either. Piping an A/C unit into your case is pretty extreme. Share this post Link to post Share on other sites More sharing options...
Nerm Posted April 21, 2012 Posted April 21, 2012 Which really doesn't qualify as "regular" air cooling either. Piping an A/C unit into your case is pretty extreme. lol, never said it wasn't extreme. I just saw were someone said it wasn't physically possible on air cooling and I just wanted to point out that it is. Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now